SoundSend settings for 3rd Party Subwoofer

SoundSend settings for 3rd Party Subwoofer

Issue: Subwoofer not producing enough bass. This will be due to the speaker trim settings and audio settings within the SoundSend APP. 

At Lithe Audio, we have tested this, and the following settings were found to be the best audio output. If the user follows these settings, this will greatly affect the subwoofer output. 

Solution:
Settings for any WiSA-enabled subwoofer and Lithe Audio Pro speaker setup. 

Within the Wisa SoundSend setup, follow the trim settings below. As shown, it is for a 7.1 system, but if you have a 5.1 system (sur not visible)

Important Note: Make sure the trim values are the same, e.g. Front L & R are -9; otherwise, as shown below, the volume will not be the same. -9 / -10



Make Sure Front L / R, Sur L / R and Rear L / R are the same values within the pair, and the centre trim adjustment is balanced to the system, e.g. -10.

SoundSend APP Speaker Trim 



SoundSend APP Audio settings 

Audio Source can be either Optical or HDMI Arc; please check how you have connected the Soundsend to your source

The Audio settings can be tweaked according to your room or acoustic taste. Leave sub on 6, and changing the others is fine till you are happy with the performance.



If any further information or help is required, please contact support@litheaudio.com 

    • Related Articles

    • WiFi PRO - How do I setup my WiSA system?

      Please ensure you have purchased a PRO WiFi Speaker with WiSA bolt-on module and WiSA SoundSend transmitter. 1. Plug the HDMI input from the WISA Soundsend into the TV’s HDMI Arc port. Once plugged in, change the sound output settings on your TV to ...

    • User Manual - WiSA SubWoofer

      Please download the WiSA SubWoofer User Manual via link -

    • How to setup and use the SoundSend transmitter with my Lithe Audio speaker

      This article will explain how to set up the SoundSend transmitter and the reason why it is used with our Wi-Fi Pro speaker with the Wisa bolt-on. Here is a video that will explain how it works. Here is a link to our web page for the SoundSend and how ...

    • Optical Input on WiFi PRO speaker - How to adjust the volume output?

      The Optical input is transmitted via a light beam at a fixed volume level, as a result the signal from the TV to the speaker does not allow volume adjustment. However, the latest firmware version p14802.190 this has been addressed. The latest update ...

    • SoundSend - How to update the Firmware?

      Here is a link to the Wisa firmware page with the latest files. Once downloaded, as per link above.... 1. Extract the bin file from the .zip archive file to your laptop/desktop computer. NOTE: You must extract the file from the archive (compressed ...