How to connect a waterproof passive rock speaker cable to a master speaker.

How to connect a waterproof passive rock speaker cable to a master speaker.

The following video will explain exactly how to connect a passive rock speaker to a master rock speaker. Also, below are points on how and links to all the products you need for the installation. 


  • Unscrew the connection plugs with the provided cable and feed them on to the secondary cable. 
  • Make sure the plugs are firmly connected to the cable ready for connection.
  • Insert and screw in the cables to the correct connection points so the cable would go from Brown to Brown and Blue to Blue.
  • Once cables are secure you then screw up each end until it's nice and tight, that's it! You're all done.


Links to our product and extra cables.

Product

https://www.litheaudio.com/garden-speakers/all-in-one-bluetooth-outdoor-garden-rock-speakerpair.html 

Power cable 

https://www.litheaudio.com/garden-speakers/lithe-audio-garden-speaker-power-extension-cable-5m.html  

Passive cable

https://www.litheaudio.com/garden-speakers/outdoor-speaker-cable-extension-for-garden-speakers-10m.html




    • Related Articles

    • My rock speaker has stopped working

      If for any reason your rock speaker has stopped working this may be due to the power supply.  1. Disconnect the power supply from the socket.  2. Make sure the power cable doesn't have any exposed cable or splits.  3. Check to see if power is present ...

    • User Manual - Rock Speaker

      User Manual - Rock Speaker

    • Spec Sheet - Rock Speaker

      Spec Sheet - Rock Speaker

    • Why is my rock speaker base silicone sealant cracking and or turning yellow?

      The Lithe Audio Rock Speaker silicone sealant can discolour or delaminate from the rock base. This shall not have an impact on the functional aspect and IP integrity of the Rock Speaker, in addition, the electronics contained inside the rock are ...

    • How to connect a Passive Speaker to the IO1?

      To connect a Passive to your IO1 Active speaker, you will need to remove the rear enclosure where your cables are fed into. So please just unscrew the 4 terminals to remove the enclosure and you should see the black and red screw terminals at the top ...